330180-X1-05 MOD:143416-42 Bently Nevada 3300 XL Proximitor Sensor

The Bently Nevada 330180-X1-05 MOD:143416-42, also cataloged as the 330180-X1-05 3300 XL Proximitor Sensor, conditions eddy-current proximity signals for shaft displacement monitoring within a Bently Nevada machinery monitoring system. The specified configuration provides a 1.0 meter, 5.0 meter, or 9.0 meter system length and CSA, ATEX, and IECEx approvals.

Hardware Specifications

Eddy-Current Signal Conditioning

The 3300 XL Proximitor Sensor forms part of an eddy-current proximity measurement chain. It interfaces with the associated probe and extension cable to produce a conditioned displacement signal for machinery monitoring equipment.

For installation, technicians should maintain the specified probe, extension cable, and sensor combination. Proper cable routing also reduces electromagnetic interference and unwanted signal coupling.

The supplied configuration identifies three system-length options: 1.0 meter, 5.0 meters, and 9.0 meters. Therefore, technicians should verify the complete probe system length before installation or replacement.

Bently Nevada proximity systems also require correct electrical reference and gap-voltage validation during commissioning. Where the applicable system documentation specifies a -10 VDC gap target, technicians should verify the actual probe bias voltage with suitable test equipment before machinery operation.

Frequently Asked Questions

Q: What system lengths are specified for 330180-X1-05 MOD:143416-42?
A: The supplied data specifies 1.0 meter, 5.0 meters, and 9.0 meters system-length configurations.

Q: Which hazardous-area approvals are identified for this configuration?
A: The supplied specification lists CSA, ATEX, and IECEx approvals.

Q: Does the supplied data specify operating temperature or power consumption?
A: No. The supplied information does not provide specific operating-temperature or power-consumption values.

Field Installation Guidelines

• Verify the complete model and configuration before connecting the sensor.
• Confirm that the installed probe, extension cable, and Proximitor Sensor match the intended system configuration.
• Route proximity-sensor cables separately from high-current power conductors where practical.
• Avoid unnecessary cable loops, sharp bends, and routing paths near strong electromagnetic interference sources.
• Maintain appropriate shielding and grounding according to the applicable Bently Nevada installation documentation.
• Verify electrical connections before energizing the machinery monitoring circuit.
• Where required by the monitoring system, perform probe gap-voltage validation before placing the machinery into service.
• Confirm the applicable CSA, ATEX, or IECEx installation requirements when installing the equipment in a hazardous area.
• Do not substitute cable lengths or sensor configurations without confirming system compatibility.