Bently Nevada 330180-X1-05 145004-47 Proximitor Sensor

The Bently Nevada 330180-X1-05 Proximitor Sensor, MOD 145004-47, conditions proximity probe signals for machinery position and vibration monitoring. It works with a matched 3300 5 mm or 3300 XL 8 mm probe and extension cable to produce an output voltage proportional to the conductive target's position. The calibrated sensing chain supports both static displacement measurements and dynamic vibration monitoring.

Signal Conditioning and Probe Matching

The Proximitor Sensor converts the electrical response from its matched proximity probe and extension cable into a voltage signal for monitoring equipment. This signal represents the relative position of a conductive target, allowing the monitoring system to measure shaft displacement and dynamic vibration.

Furthermore, the probe family and total electrical cable length must match the sensor configuration. A 3300 5 mm or 3300 XL 8 mm probe system requires the corresponding compatible sensor and extension cable. Therefore, verify the complete sensing chain before selecting a replacement.

Power Supply and Electrical Characteristics

The sensor supports different supply voltage ranges depending on whether the installation uses barriers. Without barriers, the specified supply range is -17.5 to -26 VDC. With barriers, the range is -23 to -26 VDC. The maximum current consumption is 12 mA.

In addition, the 50 ohm output resistance and supply sensitivity below 2 mV/V are important electrical characteristics when checking the sensor against the monitoring circuit and installation requirements.

Environmental and Connection Details

The housing uses A308 aluminum. Its operating temperature range is -52 to +100 deg C, while the storage temperature range extends to +105 deg C. SpringLoc terminal strips provide the field wiring connections.

For installation, select the mounting arrangement and calibrated cable length to match the existing probe and extension cable. Approval markings and factory modifications must also be checked separately rather than assumed from a similar enclosure or base model number.

Technical Specifications

Frequently Asked Questions

Q: Which proximity probes are compatible with the 330180-X1-05?

A: It accepts matched Bently Nevada 3300 5 mm or 3300 XL 8 mm proximity probe systems. The probe, extension cable and Proximitor Sensor must have a matching calibrated configuration.

Q: Does the supply voltage change when barriers are installed?

A: Yes. The specified range is -17.5 to -26 VDC without barriers and -23 to -26 VDC with barriers. Follow the applicable controlled installation drawing when checking the supply arrangement.

Q: Can the 330180-X1-05 replace another Proximitor Sensor with a similar model number?

A: Not based on model similarity alone. Check the probe family, calibrated electrical length, mounting configuration, approval markings and factory modifications before confirming interchangeability.